How to Install the Bastion Proxy?

Owned by Agat Support
Last updated: Apr 24, 2022 by Avi J. Levin (Unlicensed)
2 min read

Before proceeding make sure to follow this KB in order to generate the user properties file.


Configuration

  • Right-click the installer .exe file and click Run as an Administrator
  • When prompted with the following window select 

  • If no properties file was detected you will be asked to choose (if you have).
    Click yes, to specify a file and no to proceed without specifying. The default location of the file should be:

C:\Agat\SphereShield.Setup

          If you have a properties file skip to Installation
          Otherwise, continue below:

  • Click  until you reach the Bastion Configuration page

    Fill out the information required for the Bastion. For a detailed explanation please refer to the Bastion section in the initials installation guide.
  • Click  until you reach the Install page.

Installation

  • In the following page, you'll be able to find the various components that are available for installation and their versions. 
    Click the  button next to DMZ Bastion


  • After a successful installation, you should see a green checkmark () next to the button and label mentioning the version that is installed.


  • Open the services manager by typing in services.msc  in the run window. 
    Make sure that the AGAT Bastion service is present

Post Installation Configuration

How to Replace a Certificate in Bastion?